Hi
I have just installed the Nmea2Wifi unit in my boat. Everything works fine receiving NMEA data on my iPad over Wifi but i can´t send from my iPad. The Nmea2Wifi doesn´t seem to receive anything at all, no red led flashing or anything. I have set the right port (the default 1288 on both units) can anyone help?
I also have Navionics installed and trying to run that the app opens for a few second, reporting no internet connection and then closes down. Looking forward to get some good advice in here.
Regards
Jesper
Nmea2Wifi with iSailor and Navionics on iPad
Re: Nmea2Wifi with iSailor and Navionics on iPad
Hello Jesper,
Unfortunately I have not Ipad to test, but I suggest you use the TCP protocol for the WiFi to Wired connection. Chose a common port number for the multiplexer (the server) and the app running on the Ipad (the client). On the client side enter the IP address of the server (192.168.4.1).
Also disconnect the mobile data in order for the Ipad to chose the NMEA2WIFI network. In some cases, when the wifi networks do not have Internet connectivity (as it is the case of multiplexer), they are ignored in favour of the mobile data.
Also note that TCP only supports one connection at a time. For the other direction (multiplexer to Ipad over wifi) please use UDP.
Regards, Luis
Unfortunately I have not Ipad to test, but I suggest you use the TCP protocol for the WiFi to Wired connection. Chose a common port number for the multiplexer (the server) and the app running on the Ipad (the client). On the client side enter the IP address of the server (192.168.4.1).
Also disconnect the mobile data in order for the Ipad to chose the NMEA2WIFI network. In some cases, when the wifi networks do not have Internet connectivity (as it is the case of multiplexer), they are ignored in favour of the mobile data.
Also note that TCP only supports one connection at a time. For the other direction (multiplexer to Ipad over wifi) please use UDP.
Regards, Luis
Re: Nmea2Wifi with iSailor and Navionics on iPad
Hi Luis
Thank you for fast reply, - how do i set the TCP port on the multiplexer, i´m running firmware 4.0 and as far as i can se it has only UDP setting options
Regards
Jesper
Thank you for fast reply, - how do i set the TCP port on the multiplexer, i´m running firmware 4.0 and as far as i can se it has only UDP setting options
Regards
Jesper
Re: Nmea2Wifi with iSailor and Navionics on iPad
Hello Jesper,
You need to update your firmware. Please see this forum for instructions.
Regards Luis
You need to update your firmware. Please see this forum for instructions.
Regards Luis
Re: Nmea2Wifi with iSailor and Navionics on iPad
Hi Luis
Now i have upgraded to firmware 4.1 but i Can still not see any TCP setting options is there a newer firmware?
Regards Jesper
Now i have upgraded to firmware 4.1 but i Can still not see any TCP setting options is there a newer firmware?
Regards Jesper
Re: Nmea2Wifi with iSailor and Navionics on iPad
sorry, found it - 53 is the newest, right?