Using USB communication in pre 2021 units

Discussion and support for the Nmea2Wifi multiplexer - a 2-input Nmea 0183 wifi multiplexer.
Post Reply
Luis Sa
Site Admin
Posts: 847
Joined: Thu May 04, 2017 4:12 am

Using USB communication in pre 2021 units

Post by Luis Sa » Wed Feb 17, 2021 4:34 pm

Hello,

With firmware 6.4, you can use USB to communicate between the multiplexer and a PC or laptop. However you need to make a small modification on the PCB. You need to solder a 470R resistor between the TX and D4 pin of the Wemos D1 mini board. The resistance should be soldered under the PCB. Remove the 4 screws that hold the PCB to the box plate and place the resistance as shown in the following picture.

470R.jpg

Regards, Luis

Juanvi
Posts: 5
Joined: Tue Feb 27, 2018 7:18 pm

Re: Using USB communication in pre 2021 units

Post by Juanvi » Mon Nov 22, 2021 7:24 pm

Buenas tardes Luis, en la placa Versión 5.0 como se puede hacer esta modificación
Gracias

Post Reply