Erratic Seatalk1 conversion
Posted: Wed Oct 20, 2021 7:23 am
hello,
Just installed a brand new NMEA4Wifi device las week-end in my boat.
I see erratic Seatlak1 to NMEA conversion, for example on depth.
Sometime the value is correct, sometime it is not.
Same for water temperature.
It's constantly switching between 3 or more different value, like 2.1, 1740, etc... 2.1 being the correct one (was in the harbour).
Attached is my wiring. I first tested with ONLY Seatlak (Port4) connected and had already the issue, thus this not linked to the complexity of wiring.
On the wifi side, I have a PC with Lubuntu (Linux) and OPENCPN on UDP port 2000 and dashboard plugin showing depth.
Firmware version is 4.4.
I have seen multiple fixes in other threads regarding Seatlak and version 2.5,2.6,2.7, etc...
Could it be a bad merge/fix/bug still in 4.4 ?
(I used to be a software developper earlier in my carrier, if I can have source code, I may help)
Just installed a brand new NMEA4Wifi device las week-end in my boat.
I see erratic Seatlak1 to NMEA conversion, for example on depth.
Sometime the value is correct, sometime it is not.
Same for water temperature.
It's constantly switching between 3 or more different value, like 2.1, 1740, etc... 2.1 being the correct one (was in the harbour).
Attached is my wiring. I first tested with ONLY Seatlak (Port4) connected and had already the issue, thus this not linked to the complexity of wiring.
On the wifi side, I have a PC with Lubuntu (Linux) and OPENCPN on UDP port 2000 and dashboard plugin showing depth.
Firmware version is 4.4.
I have seen multiple fixes in other threads regarding Seatlak and version 2.5,2.6,2.7, etc...
Could it be a bad merge/fix/bug still in 4.4 ?
(I used to be a software developper earlier in my carrier, if I can have source code, I may help)